Views: 3589 Author: Site Editor Publish Time: 2021-12-22 Origin: Site
Profile wrapping machine maintenance and maintenance knowledge
1. Ensure that the coating equipment is installed horizontally, and the grounding wire should be installed. Install the independent leakage switch for safe use.
2, keep the profile wrapping machine manufacturers clean, use a compressed air machine to clean the inside and outside of the chassis dust, wire debris, etc. before starting each day.
3, profile wrapping machine workbench, the outer cover should not be placed with hard objects (scissors, pens, rulers, tools, etc.), so as not to enter the conveyor belt to damage it.
4, profile wrapping machine start by pressing the power to start, the temperature is set to 50 ~ 60 ° C, do not exceed 80 ° C to adjust the required temperature settings. Speed, temperature, pressure, etc. can be adjusted freely according to the operation requirements.
5, profile wrapping machine can not be suddenly stopped when running at high temperature, in this sudden situation, the manual belt will be used to slowly rotate the conveyor belt to prevent the conveyor belt from being damaged by high temperature.
6. Regularly clean the conveyor belt: A. When the adhesive is very hot, clean the conveyor belt once every 4 hours; B. It must be cleaned once before the machine stops.
7. Regularly apply lubrication to each transmission part of the profile wrapping machine to ensure smooth running of the profile wrapping machine for a long time.
8. If the light curing profile wrapping machine is installed in the original position, be sure to adjust the level to prevent uneven pressure or deviation and damage of the conveyor belt.
9. When sticking, please make the film as small as possible, and the width of the cloth should not be larger than the width of the profile wrapping machine. Otherwise, it may affect the sticking, and the conveyor belt may run off or the profile wrapping machine will stop.
10. The profile wrapping machine must adjust the pressure to no pressure before the machine is ready for shutdown. Turn off the heating system, maintain the conveyor belt, and then set the delay cooling or automatic shutdown.
