Operation And Maintenance Process Of Automatic Edge Banding Machine

Operation and maintenance process of fully automatic edge banding machine

Source: | Author: hzadaxdg | Published: 2020-08-28 | 55 views

1. It is strictly forbidden for operators to wear gloves to operate the equipment to avoid injuries caused by gloves being caught in the conveyor belt and rotating knives

2. Before using the equipment, check whether the temperature, voltage and air pressure of the equipment meet the requirements for use. Temperature 1 80 210

It can be appropriately increased or decreased according to the temperature and the edge banding effect. Air pressure 0 .6Mpa 0.8Mpa Voltage: three-phase 3 80 V and grounding is required

3. Adjust the height of the pressure beam to be consistent with the actual thickness of the plate, which can be appropriately reduced by 0.2mm 0.3mm

4. Before production, use discarded plates of the same thickness to test seal to confirm the edge sealing effect and whether each part of the equipment can operate normally

5. If you change the edge banding strips of different thickness, you need to adjust the tools accordingly according to the thickness of the edge banding strip, such as the thickness of the plate and

If the material is changed, the height of the pressure beam, the amount of glue, and the welt wheel need to be adjusted accordingly

6. The equipment must be kept clean and hygienic for good operation, and the accumulation of dust and debris is strictly prohibited

7. Keep the front and back parts lubricated to avoid long-term wear of the slider and guide rail. It is recommended to add lubricating oil with a viscosity of 0W 40

8. Press beam lifting screw, apply No. 0 butter once every two weeks

9. The chain of the conveyor chain should be properly greased according to the use situation

10. Fill the base of the glue-coating shaft of the glue tank with high-temperature butter every two weeks (Note: Be sure to add butter that can resist over 200 ℃)

11. Change the tool in time according to the frequency of use of the equipment and the effect of edge banding

12. The glue tank needs to be cleaned once a month to avoid the glue spreading shaft jamming and the glue return port clogging causing glue outflow.

13. Excessive deposition of carbide in the glue tank will easily lead to slow melting of the glue particles and long heating time, so it needs to be cleaned in time to avoid influence

Glue effect, etc.

Thank you for reading the article of Guangzhou Taiwan Exhibition Machinery

If you want to know more about the fully automatic edge banding machine, you can click "Contact Us"