The Group Moment Of The Edge Banding Machine Depends On The Hydraulic Cylinder Force

Thermal transfer edge banding machine The group moment of the stalk-type hydraulic cylinder depends on the hydraulic cylinder force, and also depends on the radius of the shank. Under other conditions, the crank radius is larger, and the output torque is higher. Large, but the speed of rotation slows down. The group-handle hydraulic cylinder of the edge banding machine changes its group moment during the movement. The torque level is small at start-up and then gradually becomes larger. When in the middle position, the angle between the connecting rod or the piston and the crank is 90. The torque is at most z and then gradually becomes smaller. As we all know, due to the influence of inertial force and friction, mechanical movement often requires the greatest force at start-up. The edge-gearing hydraulic cylinder of the edge banding machine is the opposite. Its small torque at both ends and large intermediate torque can not meet this requirement. Therefore, if such a hydraulic cylinder is used, the diameter of the hydraulic cylinder has to be increased to obtain a sufficient starting torque. In this way, the volume of the edge banding machine device is bound to increase.